Tag: effects

[ad_1] It’s New Years Eve and time for the final layout of 2019 and I’m pretty sure it’s the 800th on the blog! So here...

The Guitar Wiring Blog is an old established site where I picked lots of diagram when I started modifying guitars. [ad_1] I want to show...

[ad_1] You are doing a great job, now for your country and usually for us PCB effect fans! What can I say, it’s just RESPECT...

[ad_1] Here is another layout that needed to be updated / corrected. Old layout was pretty rubbish and had a couple of bugs that were...

[ad_1] I had a request for 2 red llamas on a single board and my first reaction was “just build two”. However, since there are...

[ad_1] For most pedals that run on 9V … yes, that would be fine.If you’ve built a pedal that can also draw 18V, you’ll need...

[ad_1] Had a couple of requests for this one. Very cool design and story behind this track. Note that the 120 pF cap just below...

[ad_1] What do everyone think about SMD? It seems like more and more boutique builds are going this route, and with more parts only available...

[ad_1] Got a little booster circuit that should fit together pretty easily. It’s pretty much an Electra with no clipping diodes and a large resistor...